How Wide Is A Commercial Driveway?

One-way commercial driveways and drive aisles shall have a minimum width of 12 feet.

A drive aisle connecting a driveway to a parking area may be reduced to a width of 11 feet if the connecting drive aisle is less than or equal to 25 feet in length.

How wide should a driveway be?

Driveway widths:Plan driveways with a minimum of 10 feet of width for each vehicle. If space allows, use wider spacing for easier walk-about space between vehicles, the driveway, and the sidewalk, and the vehicles and the garage or house.

What is a commercial driveway?

COMMERCIAL DRIVEWAY – A DRIVEWAY SERVING A COMMERCIAL ESTABLISHMENT, INDUSTRY, APARTMENT BUILDING FOR FOUR OR FEWER FAMILY UNITS. RESIDENTIAL DRIVEWAY – A DRIVEWAY SERVING FOUR OR FEWER PRIVATE HOMES OR AN. BUILDINGS ABUTTING A HIGHWAY. DRIVEWAY – EVERY ENTRANCE OR EXIT USED BY VEHICULAR TRAFFIC TO AND FROM LANDS OR.

How narrow can a driveway be?

Single car driveways can be as narrow as 9 feet, or as wide as 12 feet. A 9 foot driveway is quite tight and may have difficulty accommodating larger vehicles such as delivery or trash trucks.

How wide is a concrete curb?

12.04.040 Curb and gutter dimensions.

(1) Back wall of curb in height 12 inches
(5) Curb face and apron radius 1 inch
(6) Gutter width 18 inches
(7) Gutter thickness 6 inches
(8) Gutter slope to curb face 1 1/2 inches

3 more rows

Is 2 inches of asphalt enough for a driveway?

For commercial lots, granular base aggregate is dependent on usage, but is typically 8 inches. On top of this layer, residential driveways typically use 2 to 3 inches of asphalt, whereas commercial driveways use about 3 inches. The type of soil base is also critical for building an effective foundation for the asphalt.

Do I need permission to make a driveway?

You will not need planning permission if a new or replacement driveway of any size uses permeable (or porous) surfacing which allows water to drain through, such as gravel, permeable concrete block paving or porous asphalt, or if the rainwater is directed to a lawn or border to drain naturally.

What is the maximum slope of a driveway?

The maximum grade for a driveway is 25 percent, or 25 feet rise over 100 feet. Transition zones are recommended for driveways that steep.

How many square feet is a standard driveway?

Paving a typical two-car concrete driveway of 16 feet wide and 38 feet long (610 sq. ft.) without curves or slopes costs $3,040. Therefore, the average cost per square foot amounts to $4.99, although it can be higher if excavation is needed.

What is the cost to pave a driveway?

The average cost of a concrete driveway, by comparison, is almost $7,400. Other sources estimate the cost to install an asphalt driveway to be between $2,300 and $10,300. Homeowners typically pay per square foot. Reibling adds the average cost per square foot is between $3.50 and $4.50.

How deep is a concrete curb?

Dig a trench where you will pour the concrete, at least 8 inches wide, 3 inches wider than the planned curb, and deep enough to hold concrete at least 4 inches thick. The final depth of the trench depends on how far above the soil surface you want the concrete to extend.

What is a rolled curb?

A rolled curb isn’t one of them. Rolled curbs maintain the same height as the barrier curbs surrounding them, but they’re softer and more “rolled” than barrier curbs. They have a slanted design (rather than the vertical design you’d find in many old-fashioned curbs) that makes it easier for a car to drive over them.

How wide is a street curb?

Some standards do stand out as reasonable minimums. For emergency access, 20 feet is commonly accepted as a minimum width for two way traffic. In addition, eight feet is necessary for on street parking. Therefore, 28 feet is a widely accepted minimum curb face to curb face neighborhood street width.